Depending on the wire support style you have chosen, it may be possible to edit its style parameters. Here's how.
Please note: If you change wire support or wire support style, any customised wire support style parameters will be reset to default. This stops you placing equipment with inappropriate parameters.
Watch a video tutorial
Step 1: Navigate to the 'Wires' section of the Lineardraft toolbar
Step 2: Click on the 'Edit Wire Point' button
Step 3: Click on the equipment or wire point you want to edit
This will open the 'Configure' window.
Step 4: Click on the 'Customise' button in the 'Style' section of the window
Clicking this button will open the 'Customise' window. If the button is not clickable, this means your chosen wire support style does not have editable parameters.
Step 5: Adjust the wire support style parameters to your requirements, then click 'Confirm'
The parameters available for customisation are dependent on the chosen wire support style. Clicking 'Confirm' will close the 'Customise' window.
Top tip: You can reset your parameters to default at any time by clicking the 'Reset' button in either the 'Customise' or 'Configure' window.
Step 6: Click 'Confirm'
This will close the 'Configure' window and confirm your changes.
