How to Display Custom Support Symbols

If you have added custom support symbols to your project settings, then you can display them in your project by following these steps.

Please note: If you have not added custom structure support symbols to your project settings, you will not be able to display them. Find out how to add custom support symbols here.

Step 1: Navigate to the 'Structures' section of the Lineardraft toolbar

Step 2: Click 'Adjust'

Step 3: Click on the structure you want to edit

The 'Edit Structure' window will appear once you have selected a structure.

Step 4: Click 'Settings' in the bottom left of the 'Edit Structure' window

The 'Settings' window will open once you've done this.

Step 5: Navigate to the 'Structure Symbols' section in the bottom right of the 'Settings' window.

Step 6: Click the arrow to open the list of structure symbols

'Left' and 'Right' refers to which side of the associated track(s) the structure support is on, when looking in the direction of increasing chainage

If the selected structure is a portal, both 'Left' and 'Right' will be available as there are structure supports on both sides of the track(s).

Step 7: Click the symbol you want to use

Step 8: Click 'Confirm' to save changes in the 'Settings' window

This will close the 'Settings' window.

Step 9: Click 'Confirm' to save changes in the 'Edit Structure' window

This will close the 'Edit Structure' window.

Your custom structure symbol should now be displayed.

Did you find it helpful? Yes No

Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.