If you have made changes to your design and subsequently some in-span equipment is no longer showing, take a look at the quick troubleshooting tips below.
Has the span been deleted?
Does the position of the in-span equipment exceed the length of the wire run?
If you are using the 'Absolute' setting for positioning your in-span equipment on your wire, the 'Distance' value you input indicates the distance along the wire from the chosen structure measured in metres.
If the value you input exceeds the length to the end of the span or wire , your in-span equipment will not display. Try altering the 'Distance' value or alternatively using the 'Ratio' positioning method.