Wire point status can be set and changed via the 'Statuses' tab in the 'Edit Wire' window or in the 'Edit Wire' dialog. See the steps below to find out how.
Step 1: Click the 'Edit' button in the 'Wires' section of the Lineardraft toolbar
This will open the wire selection window.
Step 2: Click on the wire you want to edit and click 'Edit'
Alternatively, you can select your wire from the drop-down menu or click on a stagger symbol associated with the wire. Clicking 'Edit' will open the 'Edit Wire' window.
Step 3: Click on the 'Statuses' tab
You'll see a list of all wire points in the wire run.
More info: For a full breakdown of the 'Statuses' tab in the 'Edit Wire' window, take a look here.
Step 4: Locate the wire point of which you'd like to change the status
You can search by structure in the search box or scroll through the list.
The search results will show the wire point you've searched for highlighted; along with the preceding span, the following span and their respective wire points.
Step 5: Choose a new status from the drop-down menu
The span statuses for the preceding and following spans may change based on your selection. This is determined by your span status logic; learn more here.
Step 6: Click 'Update Wire'
This will save your changes to your design and close the window.
Step 1: Click the 'Edit' button in the 'Wires' section of the Lineardraft toolbar
This will open the wire selection window.
Step 2: Click on the wire that you want to edit
Alternatively, you can select your wire from the drop-down menu.
Step 3: Click on the structure with the wire point status you would like to edit and click 'Edit'
Make sure the locate button is red to show it is active, then click on the structure with the wire point of which you want to change the status. Alternatively, you can select your structure from the drop-down menu.
Clicking 'Edit' will open the 'Edit Wire' window directly in the 'Edit Wire' dialog.
Step 4: Click the three dots icon
Two new drop-down menus will appear.
Step 5: Select a status from the drop-down menu
Step 6: Click 'Apply'
This will close the 'Edit Wire' dialog and return you to the 'Wire points' tab of the 'Edit Wire' window.
Step 7: Click 'Update Wire'
This will save your changes to the design and close the window.
