Please note: If you change wire support or wire support style, any customised wire support style parameters will be reset to default. This stops you placing equipment with inappropriate parameters.
Step 1: Navigate to the 'Wires' section of the Lineardraft toolbar
Step 2: Click on the 'Edit Wire Point' button
Step 3: Click on the equipment or wire point you want to edit
This will open the 'Configure' window.
Step 4: Click on the 'Reset' button in the 'Style' section of the window
If the button is greyed out, this means your wire support style parameters are already set to default.
Step 5: Click 'Confirm'
This will close the 'Configure' window and confirm your changes.