C99-T07&T08 Reach Over Cantilevers

The following article will guide you through using the C99-T07&T08 reach over cantilevers in Lineardraft, by providing you with:

  • An annotated example with all limits for user adjustable values
  • The system height and reach ranges for using the cantilevers in your design

Pull Off Push Off Inverted Pull Off Inverted Push Off

C99-T07&T08 Reach Over Pull Off Cantilevers Clamp Above

Design Limits

Please note: Where design limits are not available on the drawing, design limits have been provided externally, these are marked in bold.

Standard:

  • Minimum System Height: 1135mm
  • Maximum System Height: 2500mm
  • Minimum Reach: 1790mm
  • Maximum Reach: 3100mm

C99-T07&T08 Reach Over Pull Off Cantilevers Clamp Below

Design Limits

Please note: Where design limits are not available on the drawing, design limits have been provided externally, these are marked in bold.

Standard:

  • Minimum System Height: 1135mm
  • Maximum System Height: 2500mm
  • Minimum Reach: 1790mm
  • Maximum Reach: 3100mm

C99-T07&T08 Reach Over Pull Off Cantilevers Contenary Clamp Below

Design Limits

Please note: Where design limits are not available on the drawing, design limits have been provided externally, these are marked in bold.

Standard:

  • Minimum System Height: 1135mm
  • Maximum System Height: 2500mm
  • Minimum Reach: 1790mm
  • Maximum Reach: 3100mm

Did you find it helpful? Yes No

Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.