The 'Edit Wire Point' button can be used to edit the properties of a catenary or auxiliary wire at a structure, add equipment to a structure, or edit any previously attached equipment.
Step 1: Navigate to the 'Wires' section of the Lineardraft toolbar
Step 2: Click the 'Edit Wire Point' button
Step 3: Click on the equipment or wire point you want to edit
This will open the 'Configure' window.
Step 4: Edit the wire or equipment to your requirements
There are more guided instructions on adding catenary equipment here, and adding auxiliary equipment here.
Top tip: You can customise the wire support style parameters of your chosen wire support style by clicking the 'Customise' button. Find out more here.
Step 5: Click 'Confirm'
This will close the 'Configure' window and confirm your changes.